Product purpose and functional characteristics:
This regulator is the best choice to replace the use of electromagnetic contactors in compensation devices. It is suitable for various low-voltage reactive power dynamic compensation devices in distribution systems with AC 50Hz and rated working voltage of 0.4KV, and is used for quick switching of parallel capacitors.
Functional Features:
1. There is no surge, overvoltage, or spark generation when the container is powered on
2. No noise during operation
3. Allow frequent actions
4. With overheating protection
5. Easy and convenient installation, wiring, and maintenance
Technical parameters:
1. Rated working voltage 400V (230V) AC ± 15%
2. Rated frequency: 50HZ ± 5%
3. Control capacity (three-phase co compensation 400V ≤ 40Kvar: triangular connection method) (Single phase compensation 230V ≤ 3 * 13.3KVar star connection method)
4. With discharge coil, the discharge time shall not exceed 1 second
5. Control terminal voltage: DC8-20V 20mA
6. If there are special requirements, they can be resolved through negotiation with our factory.

Installation position and size
There are two ways to install contactless switches: one is to install them on the installation plate of the compensation device, and the hole size of the installation plate is shown in the figure; The second is to install it on the rack of the compensation device. As the regulator has a radiator and a fan with temperature control below the radiator, it should be installed vertically for ventilation and heat dissipation, with the inlet end at the top and the outlet end at the bottom. Air ducts should be left between the radiator and the fan, with a recommended spacing of more than 30mm.
The external dimensions of the regulator are shown in millimeters.
Opening size: 1 13 * 153 (mm)


Copy product links
Long by picture save/share

